Remove And Replace The Double-Wide Network Module - Cisco Firepower 9300 Hardware Installation Manual

Remove and Replace the Double-Wide Network Module

Step 7
Do one of the following:
a) Power up the chassis so that the new network module is recognized (if the new network module does not support hot
swapping).
b) Bring the new network module online using the appropriate CLI command (if the new network module supports hot
swapping). The saved network module configuration is automatically reapplied when the network module is back
online.
Note If you install a network module that is a different PID than the original network module, the saved
configuration is deleted and the default configuration is applied. You must enter the acknowledge command
to confirm the network module PID change.
What to do next
Follow the procedures in the
that it has been discovered correctly by the Firepower 9300.

Remove and Replace the Double-Wide Network Module

The Firepower 100-G network module is an optional, removable I/O module that provides two fiber 100
Gigabit Ethernet interfaces. It takes up two slots in the Firepower 9300 and supports single and multimode.
Although the hardware supports removing and replacing the network module while the system is running, the
software does not currently support hot swapping. After removing and replacing the network module, you
must reboot the system so that the Firepower 9300 discovers the new network module. See
on page 14
The following figure shows the front panel view of the Firepower 9300 100-G network module.
Figure 48: 100-G Network Module
1
Cisco Firepower 9300 Hardware Installation Guide
66
FXOS Configuration Guide
for more information about Firepower 9300 network modules.
Captive screw on handle
to connect to the network module and make sure
2 100-Gigabit Ethernet QSFP28 fiber port
Ethernet X/1
Maintenance and Upgrade
Network Modules,