Cisco Firepower 9300 Hardware Installation Manual page 68

Remove and Replace the Single-Wide Network Module
Figure 46: Firepower Network Module 10G
1
3
5
7
9
Step 1 Do one of the following:
a) Power down the chassis by moving the power switch to the OFF position (if removing a network module that does
not support hot swapping).
See Chassis Components, on page 4
b) Bring the network module offline using the appropriate CLI command (if removing a network module that supports
hot swapping). All network module configuration is saved.
Cisco Firepower 9300 Hardware Installation Guide
64
Captive screw/handle
Ethernet X/3
Ethernet X/7
Ethernet X/4
Ethernet X/8
for more information about the power switch.
Ethernet X/1
2
Ethernet X/5
4
6 Ethernet X/2
8 Ethernet X/6
10 Network activity LEDs
• Off—No connection or port is not in
use.
• Amber—No link or network failure.
• Green—Link up.
• Green, flashing—Network activity.
Maintenance and Upgrade