Cisco Firepower 9300 Hardware Installation Manual page 15

Overview
3
5
7
9
RJ-45 Console Port
The Firepower 9300 has a standard RJ-45 console port. You can use the CLI to configure your Firepower
9300 through the RJ-45 serial console port by using a terminal server or a terminal emulation program
on a computer.
The RJ-45 (8P8C) port supports RS-232 signaling to an internal UART controller. The console port does
not have any hardware flow control, and does not support a remote dial-in modem. The baud rate is 9600.
You can use the standard cable found in your accessory kit to convert the RJ-45 to DB-9 if necessary.
Type A USB Port
You can use the external USB Type A port to attach a data storage device. The external USB drive
identifier is
USB Type A port
Locator/Beacon (push button):
• Off—Locate is off.
• Blue—Locate is on.
Power LED:
• Off—No power.
• Green—System has power.
SYS LED:
• Off—System is not booting up yet.
• Green, flashing—Power-up
diagnostics is complete and the
system is booting up.
• Green—System has booted up
successfully.
• Amber—Power-up diagnostics have
failed.
• Amber, flashing—Alarm; power-up
diagnostics are running.
. The USB Type A port supports the following:
disk1:
• Hot swapping
• USB drive formatted with FAT32
• Boot kick-start image from the Supervisor ROMMON for discovery recovery purposes
4 8 SFP/SFP+ ports that support 1-G or 10-G
Ethernet (copper or fiber)
6 Management LED:
• Off—No connection or port is not in
use.
• Amber—No link or network failure.
• Green—Link up.
• Green, flashing—Network activity.
8 ACT LED
This LED is not supported; reserved for
future use.
10 Network port status LEDs:
• Off—No connection or port is not in
use.
• Amber—No link or network failure.
• Green—Network activity up to 1 G.
• Green, flashing—Network activity
faster than 1 G.
Cisco Firepower 9300 Hardware Installation Guide
Supervisor
11