Kranzle bully 980 TS Operating Manual page 12

Putting into operation
Check the water inlet sieve for damage. Do not operate the
high pressure cleaner without or with a damaged filter.
Be careful when using hot water!
When running your high pressure cleaner with hot water of 60 °C raised
temperatures occur. Do not touch the metal parts of the high pressure
cleaner without safety gloves!
22
7. Check water inlet filter for cleanliness
prior to putting the high pressure
cleaner into operation.
Manually unscrew plug-in coupling.
Take out the water inlet filter using
needle nose pliers and thoroughly
rinse it with clear water and clean
it with the other parts.
8. Connect water hose to water inlet (mi-
nimum requirements; 5 m hose length,
cross-section ¾", 10 bar).The high pres-
sure cleaner may be connected to a
water mains (1-10 bar pre-pressure)
with either cold or hot water (up to
60 °C). The bully series provides the
opportunity of sucking in water out
of a container (see direct suction).
9. Each time check oil level at the oil
dipstick prior to putting the high
pressure cleaner into operation.
(Take care that cleaner is in horizontal
position!) Oil level must reach until the
upper edge of marking "OK".
Putting into operation
Do not touch the mains plug or any live parts with wet or moist hands.
10. Connect to circuit (see technical data).
11. Switch on high pressure cleaner with
opened safety trigger gun. Bleeding
of the high pressure cleaner: Pull and
release trigger of safety trigger gun
several times. Start cleaning task.
12. When using the filth killer lance make
sure that lance points downward when
starting.
13. Adjust operating pressureinfinitely
using the rotary handle. The maximum
pressure is factory-set.
14. The bully-series units are equipped
with a support for the safety trigger
gun with lance during breaks.
23