Ikelite 6171.11 Manual page 24

Strobe will not fire
•
Turn on strobe.
•
Make sure that the camera's flash is set to fire on every photo.
•
Check that the sync cord is attached.
Buttons are stuck
•
Soak the housing in lukewarm fresh water. Depress each button
several times while the housing is submerged.
•
Apply lubricant to the button. Press the button several times to
distribute the lubricant.
•
Check each housing control while underwater to ensure that
they are disengaged. An inadvertently engaged control may limit
functioning of the camera.
Button(s) or control(s) do not line up
•
Ensure that nothing is preventing the camera from going into the
housing.
•
Push the camera mounting plate forward until it is flush with the
housing base plate.
Camera is not functioning normally underwater
•
Ensure that the camera mounting plate is pushed all of the way into
the housing mounting plate.
•
Check each housing control while underwater to ensure that
they are disengaged. An inadvertently engaged control may limit
functioning of the camera.
•
Check that the zoom control is returned to the center position.
24