Lens Port; Storage - Ikelite 6171.11 Manual

Lens Port

Treat the surface of the lens port like a camera lens. After use, rinse
and gently dry the outside lens port to avoid water spotting. Use only a
microfiber lens cleaning cloth to avoid scratches. To clean, use a mild
soap solution.
Do not rinse the inside of the lens port.
»
Do not use alcohol, cleaning agents, spray lubricants, Rain-X,
»
or other solvents on the housing or lens port. Use of an
incompatible chemical compound can damage the plastic and
o-rings, and may result in leaking.

Storage

1. Clean the housing and controls thoroughly prior to storage.
2. Remove the rear o-ring. Place in a small re-sealable plastic bag
inside of the housing.
3. Leave the lid snaps open to release pressure on the lid snap
springs.
4. Store the housing in a cool, dry place away from direct sunlight and
chemicals.
5. Before using the housing, check the tightness of the set screw in
each control knob. Check each control gland to make sure they are
snug. There is a slight chance that either could vibrate loose during
travel.
Do not leave the camera and housing in direct sunlight for
»
prolonged periods. Heat may damage the camera.
Do not transport with the camera inside of the housing.
»
Do not store the housing in a humid environment. Prolonged
»
exposure to high humidity may damage electronic
components.
19