Operating Your Sage ® Milk Café; Care & Cleaning - Sage Milk Cafe BMF600 Quick Manual

OPERATING YOUR SAGE MILK CAFÉ
®
WARNING
Appliance surfaces will be hot
during and after operation.
8. Clean the milk jug and frothing disc
immediately after use. Refer to Care
& Cleaning.
NOTE
When frothing multiple batches, to prevent
the Boil Dry Protection from activating, we
recommend allowing the milk jug to cool
for approximately 5 minutes, or filling the
milk jug with water for faster cooling.
USING THE 'COLD STIR' SETTING
The 'Cold Stir' setting allows you to stir already
cold or hot milk without additional heat.
Use it to froth milk for cold beverages such as
an iced cappuccino; to blend in syrups and
flavourings for an iced chocolate or mocha;
or to stir in dissolvable instant drinking powders
into milk or water.
NOTE
The milk frother has been designed
specifically for the purpose of foaming milk
and other dairy milk alternatives and is
not intended to whip, thicken or heat other
food substances eg. oil, eggs, butter, heavy
whipping cream, soups, gravies etc.
The milk frother is not designed to mix a
large quantity of dry ingredients or melt large
food pieces eg. cubed chocolate, ground
nuts, whole spices, fresh herbs or ice cubes.
8
™
ADDING INGREDIENTS
Always allow the milk frother to start for
a few seconds before using the measuring
cap to gradually add ingredients.
Always add ingredients slowly and in small
quantities.
NOTE
Frothing results differ depending on the
ingredients used. For example, adding
dense ingredients like thick syrups, heavy
powders and large flakes can significantly
reduce the amount of foam.
SAFETY FEATURES
Boil Dry, Overheating Protection
The milk frother will automatically cease to
operate if the milk jug overheats. This can
be caused if the milk jug is empty, if liquid is
below the MIN measurement marking, or after
consecutive uses. If this occurs, 3 alerts will
sound. Unplug the power cord from the power
outlet, wait approximately 5 minutes for the milk
frother to cool down or fill the milk jug with water
for faster cooling.
Thermal Fuse & Current Protection
This feature protects the milk frother in case
of major fault. If this occurs, the milk frother
will automatically turn off and will not reactivate.
Immediately cease use, remove the power
plug from the power outlet and visit
www.sageappliances.com or call
Sage Consumer Service.
CARE & CLEANING FOR YOUR SAGE
Both the milk jug and frothing disc should be
cleaned immediately after each use to prevent
build-up of milk residue.
1. Unplug the power cord from the power outlet
before cleaning.
2. The milk jug and frothing disc will be hot
immediately after use, so carefully remove
the milk jug from the power base and fill with
tap water. Once the milk jug and frothing disc
have cooled completely, remove the frothing
disc and rinse off any milk in warm water.
3. Wash the milk jug, jug lid, measuring cap
and frothing disc in warm soapy water, rinse
and dry thoroughly.
The seal from the lid can be removed and
washed separately.
4. Wipe the exterior of the power base with
a soft damp cloth. Dry thoroughly.
NOTE
Do not use alkaline or abrasive cleaning
agents, steel wool or scouring pads on any
part of the milk frother as these can damage
the appliance surfaces.
NOTE
Never immerse the power base in water
or any other liquid. The outside of the milk
jug must always be clean and dry before
placing on the power base prior to use.
NOTE
The milk jug, jug lid, measuring cap and
frothing discs can be washed in
the dishwasher (top shelf only). However
to extend the life of the frothing discs, we
recommend these are washed by hand.
MILK CAFÉ ™
®
EN
9