Suzuki SQ416 Service Manual page 83

7B1-12 AUTOMATIC TRANSMISSION (4 A / T)
Coil outer diameter and free length of each valve spring :
Name of spring
Pressure relief valve spring
TCC (Lock-up) control valve
spring
Valve damping spring
Low coast modulator valve spring
Inter coast modulator valve
spring
Ball valve spring
Bypass valve spring
Primary regulator valve spring
1. Solenoid valve No.1
(Shift solenoid valve)
2. Low coast modulator
valve spring
3. Inter coast modulator
valve spring
4. Intermediate coast
modulator valve
5. Low coast modulator valve
ASSEMBLY
Assemble each component by reversing disassembly procedure
and noting the following points.
D Coil outer diameter and free length of each valve spring should
be as listed below. Be sure to use each one of correct size.
Outer diameter
13.14 mm (0.517 in.)
11.40 mm (0.449 in.)
4.95 mm (0.195 in.)
10.00 mm (0.394 in.)
9.04 mm (0.356 in.)
(G16 and J20 engines)
10.00 mm (0.394 in.)
(H25 engine)
10.50 mm (0.413 in.)
13.82 mm (0.544 in.)
17.02 mm (0.670 in.)
D Install primary regulator valve sleeve so that its tip is positioned
as it was before disassembly.
D Use new TCC (lock-up) control valve gasket, solenoid gasket and
lower valve body plate gasket.
D Tighten shift solenoid valve bolt to specified torque.
Tightening torque
Shift solenoid valve bolt: 10 N
Free length
32.14 mm (1.265 in.)
32.60 mm (1.283 in.)
20.00 mm (0.787 in.)
42.35 mm (1.667 in.)
27.26 mm (1.073 in.)
(G16 and J20 engines)
25.60 mm (1.008 in.)
(H25 engine)
13.70 mm (0.539 in.)
28.90 mm (1.138 in.)
50.28 mm (1.980 in.)
.
m (1.0 kg-m, 7.5 lb-ft)