Suzuki SQ416 Service Manual page 90

2
23) Apply 2 – 4 kg/cm
numbered and check operation sound of each part.
(1) O/D clutch
(2) O/D brake
(3) Forward clutch
(4) Direct clutch
(5) B1 brake (Second coast brake)
(6) B2 brake (Second brake)
(7) Reverse brake
24) Take down transmission from stand and measure clearance in
shaft direction by applying dial gauge (1) to output shaft as
shown in the figure.
Standard clearance in shaft direction:
0.3 – 0.9 mm (0.012 – 0.035 in.)
25) Check that inner shaft runs smoothly.
26) Install parking lock pawl (1), pawl pin (2) and pawl spring (3) to
transmission case.
27) Apply grease to lip of new oil lip seal and drive in oil lip seal with
special tool till it contacts transmission case.
Special tool
(A): 09943-88211
28) After installing new sleeve cover to manual shift lever (1), install
manual shift shaft (2) and manual shift lever (1) to transmission
case.
AUTOMATIC TRANSMISSION (4 A / T) 7B1-19
air pressure into fluid holes in the figure as