Connecting Using The Fisher Easy-Drive Configuration Software - Fisher easy-Drive 200L Instruction Manual

easy-Drive 200L
December 2018
Connecting using the Fisher easy­Drive configuration software
The Fisher easy­Drive configuration software allows configuration and diagnosing of the Fisher easy­Drive electric
actuator with a graphical interface. Connect a PC to the actuator using a USB or serial device to RS-485 converter using
the wiring instructions above. The USB or serial device will be visible in the drop menu under Serial Port Settings. Baud
rate and parity should be set to the Modbus settings of the actuator. Default actuator settings are address 1, 9600
baud, even parity, 1 stop bit, MSB. Press the AUTO button in the upper left corner to connect to the valve.
Use the Fisher easy­Drive configuration software (figure 10) to make the desired changes, or register values may be
changed to allow different functionality.
Valve Type Configuration
D Valve Type
H 0.5" Fixed
H 0.62" Fixed
H 0.75" Fixed
H Stop-to-Stop
Figure 11. Fisher easy-Drive Configuration Software
Fixed travel settings will set the fixed travel from the valve seat (push down to close) up, i.e., 0.50" Fixed, will set the
full range of travel at 0.5 inches from the seat.
Stop-to-stop setting will set the travel using hard stops that define the full range (max 0.75 inches).
12
Instruction Manual
D104331X012