Battery Charging; Operation - JLG 1930ES Operation And Safety Manual

SECTION 3 - MACHINE CONTROLS, INDICATORS AND OPERATION
3.5

BATTERY CHARGING

Operation

NOTE: Be sure that machine is parked in a well ventilated area
before charging begins.
ONLY PLUG THE CHARGER INTO A PROPERLY INSTALLED AND GROUNDED
OUTLET. DO NOT USE GROUND ADAPTORS OR MODIFY PLUG. DO NOT TOUCH
NON-INSULATED PORTION OF OUTPUT CONNECTOR OR NON-INSULATED BAT-
TERY TERMINAL.
ALWAYS DISCONNECT THE AC SUPPLY BEFORE MAKING OR BREAKING THE
CONNECTIONS TO THE BATTERY BEFORE CHARGING.
DO NOT OPEN OR DISASSEMBLE CHARGER.
DO NOT OPERATE CHARGER IF THE AC SUPPLY CORD IS DAMAGED OR IF THE
CHARGER HAS RECEIVED A SHARP BLOW, BEEN DROPPED, OR OTHERWISE
DAMAGED IN ANY WAY.
The battery charger AC plug (1) is located at the rear of the
machine under the platform ladder.
1. Connect the charger to a grounded outlet.
3-4
2. On the battery charger, the charger will automatically
turn on and go through a short LED indicator self-test.
All LED's will flash in sequence for two seconds.
3. The batteries are fully charged when green light on
the ground control battery charger status panel (2), is
illuminated.
3121655