JLG 1930ES Operation And Safety Manual page 31

Begin the Walk-Around Inspection at Item 1, as noted on the
diagram. Continue left (counterclockwise viewed from top)
checking each item in sequence for the conditions listed in
the following checklist.
TO AVOID POSSIBLE INJURY, BE SURE MACHINE POWER IS "OFF" DURING
WALK-AROUND INSPECTION.
DO NOT OVERLOOK VISUAL INSPECTION OF CHASSIS UNDERSIDE. CHECKING
THIS AREA OFTEN RESULTS IN DISCOVERY OF CONDITIONS WHICH COULD
CAUSE EXTENSIVE MACHINE DAMAGE.
INSPECTION NOTE: On each item, make sure there are no loose
or missing parts, that they are securely fastened, and that no visible
damage exists in addition to any other criteria mentioned.
1. Platform Control Console - Placard secure and legible,
control lever and switches return to neutral, control lever
lock and emergency stop switch function properly, manual
in storage box.
2. Steer Cylinder - See Inspection Note.
3. Spindle, Tie Rod, Drive Motor and Steer Linkage (left
front) - See Inspection Note.
4. Wheels and Tires - Properly secured, no missing lug nuts.
Refer to Section 6, Tires and Wheels. Inspect wheels for
damage and corrosion.
3121655
SECTION 2 - USER RESPONSIBILITIES, MACHINE PREPARATION & INSPECTION
NOTICE
5. Pothole Protection System - See Inspection Note.
6. Battery Compartment - Proper electrolyte level.
7. Manual Descent - See Inspection Note.
8. Beacon - See Inspection Note.
9. Rotary Angle Switch - See Inspection Note.
10. Ground Controls - Placard secure and legible, control
switches return to neutral position, emergency stop switch
functions properly. Control markings legible.
11. Hydraulic Pump/Motor, Control Valve Installation - No
unsupported wires or hoses; no damaged or broken wires -
See Inspection Note.
12. Lift Cylinder - See Inspection Note.
13. Spindle, Tie Rod, Drive Motor and Steer Linkage (left
front) - See Inspection Note.
15. Scissor Arms, Pivot Pins and Sliding Wear Pads (Not
Shown) - See Inspection Note.
16. Platform/Handrail Installation (Not Shown) - See Inspec-
tion Note.
2-7