Thermoplan Tiger Programming Manual page 18

Menu 7
7-4 Grounds
0300 gramm
7-5 Drawer Time
7-8 Cleaning
Periodic
7-20 Cleaning-Period
24 h
7-2 Cleaning TIme
hh:mm
8:00
7-23 Clean Labyrinth
00
7-24 Preheating Activ
Yes
7-29 CPU -> EPROM
<- No Yes ->
7-30 EPROM -> CPU
<- No Yes ->
© 2006 by Thermoplan, Subject to change
Technical Manual
In menu 7-4 you can set the coffee grounds quantity with the Plus-/Minus levers.
In menu 7-5 you can adjust the desired time for the drawer. If you remove the drawer from the coffee machine, than
must the drawer in these fixed time be outside. (This is the time for the disposal of the coffee grounds in the bin).
In menu 7-8 you can set the cleaning between Periodic and Fixed Time.
Periodic: The cleaning counter starts after the product. The periode can you set on the menu 7-20.
Fixed Time: The cleaning is always on the same time.
In menu 7-20 you can set the cleaning periode. This time is for the cleaning counter, if menu 7-8 Periodic.
In menu 7-20 you can set the fixed time for the cleaning.
This menu are available only, if menu 7-18 on fixed time adjusted.
In menu 7-23 you can set the cleaning of the labyrinth plate. Range is from 00 to 23.
Exampel:
00: You don't have to remove and clean the labyrinth plate after each daily cleaning process. If the display mes
sage orders his point, you can step forward with the rinse key.
05: The machine orders every fifth daily cleaning process the removal and cleaning of the labyrint plate. You have
to clean it and can't step forward in this case.
In menu 7-24 is the system heated by the backrinse.
In menu 7-29 you can transfer the adjustments of the products parameter from CPU to EPROM.
In menu 7-30 you can transfer the adjustments of the products parameter from EPROM to CPU.
Tiger REV-8
SECTION 3
8