PIAGGIO Fly 125 ie Manual page 17

activated by switching off the engine with the RUN OFF switch (if available). This
happens even if the starter key is in «ON».
When additional keys are required, please note that data storage (up to 3 keys max.)
must be done on all keys, both new ones and existing ones. Take the key with the
brown grip and all the blue keys supplied to an Authorised Piaggio Service Cen-
tre. The codes of keys not submitted for the new programming procedure are deleted
from the memory. Any lost keys will therefore not be enabled to start the engine.
WARNING
EACH KEY HAS ITS OWN AND UNIQUE CODE, WHICH MUST BE STORED IN
THE SYSTEM CONTROL UNIT MEMORY.
VIOLENT SHOCKS MAY AFFECT THE ELECTRONIC COMPONENTS OF THE
KEY.
SHOULD THE VEHICLE CHANGE OWNER, IT IS ABSOLUTELY NECESSARY
THAT THE NEW OWNER GET POSSESSION OF THE KEY WITH THE BROWN
GRIP (AS WELL AS ALL OTHER KEYS).
Procedure start-brown key
Insert the brown key into the ignition switch (in the «OFF» position), turning it to the
«ON» position. After 1 - 3 seconds, turn the key to «OFF » again and pull it out.
Intermediate step-blu key
After extracting the brown key, insert the blue key within 10 seconds and promptly turn
it to «ON». After 1 - 3 seconds, turn the key to «OFF» again and pull it out.
In this way, a maximum of 3 blue keys can be programmed by repeating the above
procedure and keeping the indicated times.
17