Spark Plug Dismantlement - PIAGGIO Beverly Tourer 300ie User Manual

Spark plug dismantlement (03_08, 03_09)

Proceed as follows:
1. Remove the access cover over the spark plug on the right-hand side of the scooter
and reach into the spark plug with your hand;
2. Disconnect spark plug HV wire cap «A»;
3. Unscrew the spark plug using the spark plug wrench supplied;
4. When refitting, place the spark plug into the hole at the required angle and tighten
by hand until it is finger tight;
03_08
5. Use the wrench only for final tightening of the spark plug;
6. Place hood «A» fully over the spark plug.
N.B.
USING SPARK PLUGS OTHER THAN THE INDICATED TYPE OR SHIELDLESS
SPARK PLUG CAPS CAN CAUSE ELECTRICAL SYSTEM FAILURES.
WARNING
03_09
THE SPARK PLUG MUST BE REMOVED WHEN THE ENGINE IS COLD. CHECK
AND REPLACE THE SPARK PLUG AS INDICATED IN THE SCHEDULED MAIN-
TENANCE TABLE. USING NON-COMPLYING ELECTRONIC CENTRAL UNITS
AND ELECTRONIC IGNITIONS OR SPARK PLUGS OTHER THAN THOSE PRE-
SCRIBED MAY SERIOUSLY DAMAGE THE ENGINE. IF THE SPARK PLUG IS
REMOVED AFTER THE ENGINE HAS FLOODED, IT IS RECOMMENDED TO
KEEP THE TUBE CONNECTED TO THE SPARK PLUG AND THE SPARK PLUG
IN CONTACT WITH A GROUND CONNECTION FAR FROM THAT SPARK PLUG
HOLE IN ORDER TO PREVENT EXPELLED FUEL FROM CATCHING FIRE.
Characteristic
Spark plug
NGK CR8EKB
45