4.1.13.1 Error messages regarding temperature compensation
4.1.14 External display ON / OFF
Press
"SELECT"
14 x
4.1.15 Selecting analog interface (optional)
Press
"SELECT"
15 x
16
Err1
Err2
Err3
Display
YE5
EA.Ei
no
EA.Ei
Display
no
5t.Ei
- Temperature-compensation selection is set to "no
- Temperature compensation was started during the warm-up
phase.
- Device had not cooled sufficiently prior to temperature
compensation.
- Ambient temperature fluctuated greatly during temperature
compensation.
- ADC values show excessive temperature sensitivity.
- Foreign gases are diffused into the system during tempera-
ture compensation.
- If temperature compensation was terminated incorrectly, all
further measurement is disabled.
Meaning/function
Press the "Enter o" button to switch the external display on
or
external display off.
When the external display is switched on, the printer selec-
tion is automatically set to the internal printer.
Meaning/function
Press the "Enter o" or "Test u" buttons to alter the entry in
the engine-speed display window.
no no
no
no
no
Analog output not activated
0 0 0 0 0
Measuring range 0 to 20 mA
4 4 4 4 4
Measuring range 4 to 20 mA
no
no no
no".