Table of Contents
Advertisement
Installation instructions
Only competent, trained personnel (experts) may install,
start up and repair the Truma product with considera-
tion of the installation and operating instructions and
the current recognised rules of engineering. Experts
are persons who, based on their professional training,
their knowledge of and experience with Truma products
and the relevant standards, are able to carry out the re-
quired work properly and recognise potential hazards.
Scope of delivery
Truma E-Kit
E-Kit fastening accessory kit
E-Kit screw accessory kit
E-Kit electric parts accessory kit
Optional accessories
Duct adapter
Choosing a location
Dimensions
(All dimensions are in mm)
270
Figure 1
260
Truma E-Kit
190
Figure 2
Install the Truma E-Kit only in a location that is protected from
moisture and wetness. It must not be installed beneath a sink
or water container.
Truma E-Kit
600
123
A water pipe may be placed on the warm air duct only if there
is a gap of at least 1.5 m to the heater.
The Truma E-Kit must not be used to heat driver or passenger
compartments of motor vehicles.
The Truma E-Kit must be installed so that it is easily accessi-
ble at all times for servicing and can be easily removed and
re-installed.
Install the Truma E-Kit so that there is a gap of at least 6 mm
all round to furniture or parts of the vehicle.
Do not block the warm air outlets of the Truma E-Kit. It must
be possible for warm air to blow out freely for at least 30 cm.
Depending on the installation situation, additional space may
be required for connections (warm and circulation air ducts).
The Truma E-Kit must be installed so that the driver and pas-
sengers cannot come into contact with the appliance under
normal driving conditions.
The functions of parts of the vehicle that are important for op-
eration must not be adversely affected.
The Truma E-Kit may not be installed directly beneath a wall
power point.
To ensure that components inside the appliance are not dam-
aged, do not fix cables or water pipes to the housing of the
appliance.
Check whether the vehicle has a load-bearing floor or an
access or intermediate floor to fix the heater – if this is un-
suitable, create a load-bearing surface beforehand (e.g. glue
a sheet of plywood on to the floor). The same requirements
must be observed for mounting on a wall.
The Truma E-Kit may be installed in the vehicle only with the
supplied mounting bracket.
Installation location
Floor installation
The Truma E-Kit may be installed only on a level surface with
a maximum horizontal incline of ± 10°.
Figure 3
It must not be installed at an angle (incline > ± 10°).
Wall installation
The Truma E-Kit may be installed on a wall only horizontally.
The horizontal incline must not exceed ± 10°.
Figure 4
The electronics housing (E) must face downward. It must
not be installed vertically or at an angle (incline > ± 10°).
± 10°
Truma E-Kit
E
± 10°
3
Advertisement
Table of Contents
