Power Supply 12 V; Power Supply 230 V; Controlling The Truma E-Kit; Function Check - Truma E-Kit AU Installation Instructions Manual

Power supply 12 V

Electric cables, switching and control devices for heaters
must be arranged in the vehicle so that they function per-
fectly under normal operating conditions. All cables that lead
outside must be laid so that they are protected against spray
water at the hole.
Before starting work on electrical parts, you must disconnect
the appliance from the power supply. It is not sufficient to
switch it off on the control panel!
If electric arc welding is to be carried out on bodywork, dis-
connect the appliance from the on-board power supply.
Attach the 12 V connector cable to the electronics of the
Truma E-Kit and connect the 12 V
positive cable with a 1 A fuse (supplied) near the positive pole
of the power supply.
Truma E-Kit
Figure 20

Power supply 230 V

All electrical work and permanent wiring must be
carried out by a qualified person in accordance with
the standards AS/NZS 3000, AS/NZS 3001 and all local
codes and regulatory authority requirements. According to
Standard AS/NZS 3001.2008 "Electrical installations – Trans-
portable structures and vehicles" all electric circuits must be
protected with an RCD (residual current device).
Make the connection to the power supply by attaching the
supply cord to a line that is protected with at least 10 A
(preferably 16 A).
Lay the connector cables so that they cannot chafe. Also use
edge protection or leadthrough bushings on sharp edges, such
as holes on metal walls. The connector cables must not be fixed
to or touch the exhaust duct (of Truma VarioHeat), the housing or
the warm air ducts of the Truma E-Kit (minimum gap: 5 cm).
All cables must be secured with clamps.
For maintenance and repair work, the vehicle must have a
separator for complete separation from the power supply
with a minimum contact distance of 3.5 mm.
6
power supply. Protect the
TIN 12 V

Controlling the Truma E-Kit

Use TIN connecting cables to connect the Truma VarioHeat and
the Truma CP plus VarioHeat control panel with the Truma E-Kit.
Truma E-Kit
Figure 21

Function check

Then check all functions of the appliance in accordance with
the operating instructions of Truma CP plus VarioHeat.
Hand the operating instructions over to the vehicle owner.
The year when the appliance was first put into operation
must be marked with a cross on the type plate.

Technical data

Rated power at 230 V
Level 1: 900 W
Level 2: 1800 W
Rated power at 12 V
approx. 2 W
Temperature range
-30 °C to 50 °C
Weight
2.2 kg
Protection type
IPX0B
Protection class
Class 1