Table of contents
Symbols used ........................................................................ 3
Intended use .......................................................................... 3
Approval ................................................................................ 3
Regulations ........................................................................... 3
Fuel connection .................................................................. 7
Water connection .............................................................. 9
........................................................ 11
Initial start-up ................................................................... 12
Function check ................................................................ 12
Warnings ........................................................................... 12
Trademark information
Truma Combi®, referred to as Combi below.
Symbols used
Symbol indicates a possible hazard.
Comment including information and tips.
Observe the ESD-regulations! An electrostatic charge
can destroy the electronics. Ensure potential equalisa-
tion before touching the electronics.
Installation instructions
The installation and repair of the appliance is only to be
carried out by an expert. Read the installation instructions
carefully prior to starting work and observe the instructions!
Non-compliance with installation instructions or
incorrect installation can result in endangerment
of persons and property.
Please pay attention to the ESD regulations!
Intended use
The Combi D diesel heater is a warm-air heater with integrat-
ed hot water system (10 litre volume). This unit was designed
for installation in motor homes and caravans. The applicable
regulations must be complied with when the equipment is
being installed in special vehicles and vehicles for transporting
hazardous goods.
Approval
Conformity Declaration
The heater complies with UNECE Regulation No. 122 and
bears the type approval number: E1 122R 000232
The heater complies with UNECE Regulation No. 10 and
bears type approval number: E1 10R 035277
The heater is approved for installation in passenger vehicles
(class M1 motor homes) with no more than 8 seats excluding
the driver's seat, and for trailers (class O caravans).
The year when the equipment was first put into opera-
tion must be indicated with a check on the type plate.
Regulations
Guarantee claims, warranty claims and acceptance of liability
will be ruled out in the event of the following:
- modifications to the unit (including accessories),
- modifications to the exhaust duct and the cowl,
- failure to use original Truma parts as replacement parts and
accessories,
- failure to follow the installation and operating instructions.
It also becomes illegal to use the appliance, and in some
countries this even makes it illegal to use the vehicle.
Installation instructions for vehicles
This appliance shall be installed in accordance with the man-
ufacturer's installation instructions, municipal building codes,
electrical wiring regulations. AS/NZS 3500.4 "Plumbing and
Drainage Part 4: Heated Water Services" and any other statu-
tory regulations.
This appliance delivers hot water at temperatures exceeding
50 °C. Refer to AS/NZS 3500 and local regulations regarding
the need for additional hot water delivery temperature control
when hot water is supplied to sanitary fixtures primarily used
for the purpose of personal hygiene.
The relevant employer's liability insurance association acci-
dent prevention regulations must be observed in Germany for
vehicles used for commercial purposes.
In other countries, the relevant regulations must be observed.
More information on the regulations in the relevant
destination countries can be requested from our foreign repre-
sentatives (see www.truma.com).
3