Cutting Track To Length - Screen Innovations Zen Box Owner's Manual

WALL MOUNT -
2
First make sure that the set screws holding the bracket front plates on are turned out as much as
they can while still being installed. Then, lift the case up onto the hook on the back of the brackets.
Then rotate case up to flush with the bracket and secure with the front wall bracket plate.
Zen Box - Shyzip - Wall mount

CUTTING TRACK TO LENGTH -

Carefully measure the distance from the indent in the back bottom of the case to the ground
on both ends.Then cut the bottom end of each assembled track to 1/4'' less than the measured
length. DO NOT cut the top of the track as denoted by the plastic portion sticking out of the top.
You can cut through the assembled track all at once. Make sure to save the cap installed on the
bottom end and reinstall it after track assembly is cut.
L
Pg 9 Zen Box - Shyzip - Cutting track to length
1
Top Left Top Right
L - 1/4" R - 1/4"
Cut this end
R
Pg 10