Table of Contents
Advertisement
POWER (MOTORIZED ONLY)
To be installed and/or used in accordance with the appropriate electrical codes and
regulations by a licensed electrical professional. Do not connect power with the circuit
breaker on.
Before connecting power to multiple units be aware that the limits must be set with power
connected to only one unit at a time. Plan accordingly.
Power connection exits out of the back of the box on the side specified when ordered. Use
appropriate building codes and run and connect the power cable to an appropriate outlet. Note, you
can run the power cord through the track assembly if needed.
Neutral White
Hot Black
Ground Green
Zen Box - Power (Motorized only)
SET LIMITS (MOTORIZED ONLY)
Programming mode
Before you begin
Motors are shipped without limit settings and transmitter ID's. Steps 1 to 7 must be completed to ensure
proper shade programming and functionality. Power should ONLY be connected to current shade being
programmed. All other shades should be disconnected from their respective power while programming
Step 1. Connect Power
With the motor installed in shade, connect power to the motor 120V
Step 2. Initiate Programming
Press both
my
motion. In Programming Mode, the shade will move only when the
Step 3. Check Directions
Press
my
and hold
Step 4. Set the Limits
Bring the shade to desired upper limit stop point. Press both
my
motor moves, then release. (If the shade stops when the buttons are released take it back to
the upper limit and repeat). Stop the motor when reaching the desired lower limit. You can
adjust by pressing
Step 5. Set the Limits
Press both
my
shade will stop at the original upper limit.
Step 6. Confirm limit settings
Press and hold
my
and down motion.
Step 7. Set user mode
Press and hold the programming button on the back of the transmitter until the shade jogs.
The shade is now in User Mode. In User Mode, the shade will operate with a brief press on
or
Pg 21
Zen Box - Set limits (Motorized only)
and
at the same time until the shade jogs. A jog is a brief up and down
or
. While pressing
product should go down or out. To change direction press
(Stop) until shade jogs. A jog is a brief up and down motion.
my
or
.
(Stop) and
at the same time until the shade moves, then release. The
my
(stop) unitl the shade jogs to confirm the limit settings. A jog is a brief up
my
. Double check limit settings as a precaution.
or
is held.
(Stop) and
until the
my
Pg 22
Advertisement
Table of Contents
