Filling In Oil - Siemens MOTOX BA 2010 Operating Instructions Manual

Service and maintenance
8.2 Checking and changing lubricants
7. After flushing, immediately seal the gearbox using the sealing elements.
8. Repeat this step for the second rinse.
You have now flushed the gearbox twice and can pour in the new oil.
8.2.6.4

Filling in oil

NOTICE
Mixing different oils impairs the lubricating capability
When adding oil, use the same oil type and viscosity. When changing mutually
incompatible oils, see Flushing the gearbox (Page 67).
Observe the symbols in the diagrams of the mounting positions (Page 87).
Ventilation
Procedure
1. Remove the vent plug or oil filler screw.
2. Fill the gearbox with fresh oil. Use a filler filter with mesh of max. 25 μm.
3. Check the oil level.
4. Rectify the oil level if necessary and check it again.
5. Check the state of the sealing ring on the sealing element. If the sealing ring is damaged,
replace the sealing element with a new one.
6. After filling with oil, seal the gearbox immediately using the sealing element.
You have now filled up the gearbox with oil.
68
Oil filling
Operating Instructions, 02/2018, A5E38093846A/RS-AC
BA 2010