Removing And Installing The Shaft-Mounted Gearbox; General Information On Installing The Shaft-Mounted Gearbox - Siemens MOTOX BA 2010 Operating Instructions Manual

Procedure
1. Undo the screws
2. Fit the output shaft.
3. Using a suitable cleaning agent, clean the contact surface of the protection cover
the gearbox.
4. With the protection cover for shrink disk in the ATEX version, ensure that the O-ring
correctly seated.
5. Coat the supporting surface of the protection cover
6. Screw on the protection cover
7. Protect all remaining bare areas with a suitable permanent anti-corrosive agent.
You have now installed the protection cover for operation.
4.10

Removing and installing the shaft-mounted gearbox

4.10.1

General information on installing the shaft-mounted gearbox

NOTICE
Damage to shaft sealing rings caused by solvent
Avoid any contact of solvent or benzine with the shaft sealing rings.
NOTICE
Subjecting stress to the hollow shaft causes bearing failure
Skewing or stressing the hollow shaft increases the loading. This can cause bearing failure.
The hollow shaft must be flush with the machine shaft to avoid misalignment.
Do not subject the hollow shaft to axial and radial stress.
NOTICE
For shrink disks:
Lubricants in the area between the hollow shaft and machine shaft impair torque
transmission
Keep the bore in the hollow shaft and the machine shaft completely grease-free.
Do not use impure solvents and soiled cleaning cloths.
BA 2010
Operating Instructions, 02/2018, A5E38093846A/RS-AC
4.10 Removing and installing the shaft-mounted gearbox
①
and remove the protection cover
②
.
②
.
②
with a suitable sealing agent.
Installation
②
on
⑤
is
37