Installing And Removing The Shaft-Mounted Gearbox; General Information On Installing The Shaft-Mounted Gearbox - Siemens MOTOX Worm Gearbox S BA 2012 Operating Instructions Manual

4.9

Installing and removing the shaft-mounted gearbox

4.9.1

General information on installing the shaft-mounted gearbox

NOTICE
Damage to shaft sealing rings caused by solvent
Avoid any contact of solvent or benzine with the shaft sealing rings.
NOTICE
Subjecting stress to the hollow shaft causes bearing failure
Skewing or stressing the hollow shaft increases the loading. This can cause bearing failure.
The hollow shaft must be flush with the machine shaft to avoid misalignment.
Do not subject the hollow shaft to axial and radial stress.
Note
Coat the contact surfaces with the mounting paste supplied with the product or any suitable
lubricant to prevent frictional corrosion.
Note
Observe the permissible concentricity tolerance of the cylindrical shaft end of the machine
shaft to the housing axle according to DIN 42955.
BA 2012
Operating Instructions, 02/2018, A5E38093971A/RS-AB
4.9 Installing and removing the shaft-mounted gearbox
Installation
23