Show Voip Interface; E1/T1, Bri - AudioCodes Mediant 800 MSBG Cli Reference Manual

CLI Reference Guide
6.2

show voip interface

The following commands define the show voip commands.
6.2.1

E1/T1, BRI

This command displays the current status, main PM parameters and main configuration
parameters to a specific PSTN interface (E1/T1 or BRI).
Syntax:
The syntax of this command includes the following variations:
show voip interface e1-t1 <slot/port>
show voip interface bri <slot/port>
The command syntax format is described below:
Arguments
slot
port
Related Commands:
interface e1-t1 <slot/port>
interface bri <slot/port>
The above commands enter a specific PSTN interface (E1/T1 or BRI) configuration.
Notes
The displayed parameters depend on the protocol type.
Examples:
The following example displays the current status, main PM parameters and main
configuration parameters.
show voip interface e1-t1 1/1
show voip interface bri 1/2
Mediant 800 - MSBG# show voip interface bri 1/2
show voip interface bri 1\2
-----------------------------
module/port:
trunk number:
protocol:
state:
alarm status:
d-channel status:
loopback status:
main performance monitoring counters collected in the last 330
seconds:
Slips:
Version 6.4
Defines the module slot index as shown on the front panel.
Defines the port index within the selected module.
1\2
1
bri_euro_isdn
active
LOS 0, LOF 0
not established
no loop
25
155
Description
Slip seconds:
6. Show Commands
1
January 2012