Cli-Terminal - AudioCodes Mediant 800 MSBG Cli Reference Manual

4.2

cli-terminal

This command configures the CLI management interface.
Syntax:
This configuration set includes the following sub-commands:
set ssh <on | off>
set ssh-acl <acl-name>
set ssh-port <port-num>
set ssh-admin-key <rsa-key>
set wan-ssh-allow <on | off>
set telnet <enable | disable | ssl>
set telnet-acl <acl-name>
set telnet-port <port-num>
set wan-telnet-allow <on | off>
set idle-timeout <timeout-minutes>
set password-obscurity <on | off>
Arguments
ssh
ssh-acl
ssh-port
ssh-admin-key
wan-ssh-allow
telnet
telnet-acl
telnet-port
wan-telnet-allow
idle-timeout
password-obscurity
Command Modes
Enable
CLI Reference Guide
Enables or disables SSH access.
Selects an access-list permitting clients to connect to the SSH
interface. The access-list is defined under "configure data".
Selects the TCP port number on which SSH is active.
Sets the RSA key (entered as hexadecimal digits) of the SSH
client. See the Product Reference Manual for further
information on SSH access using an RSA key.
Allows access to SSH from the WAN interface.
Enables or disables Telnet access.
Selects an access-list permitting clients to connect to the
Telnet interface. The access-list is defined under "configure
data".
Selects the TCP port number on which Telnet is active.
Allows access to Telnet from the WAN interface.
Configures how long a CLI session may remain idle, before
being disconnected by the device.
Hides PPP passwords in the output of "show running-config".
42
System and VoIP Functionalities
Description
Document #: LTRT-17940