Charger - HAKO Scrubmaster B 120 R Service Booklet

6. Machine settings

6.1.4 Charger

In this menu item (0.4.X), it is specified whether the machine features an integrated
charger and whether this charger communicates with the machine control unit via
CAN bus.
With chargers that communicate with the machine, there are various selection options.
If the charger with free characteristic curve selection is selected, the correct
characteristic curve must be determined using the charger documents and then set
correctly under 0.5.X. The column under 0.4.2 in Table 6.4 then applies to this setting.
When selecting the chargers Exide (0.4.4), Hoppecke (0.4.5) and Hawker (0.4.8), only
the characteristic curves that can be operated by these manufacturers with these
chargers are shown under 0.5.X (see Table 6.4 in the columns 0.4.4; 0.4.5 and 0.4.8)
To check and change the setting, access the programming level as described in
Chapter 2.2.4. The possible setting parameters are specified in Table 6.4.
Sheet 50