13.1 Digital Operator Monitor Display - Saftronics FP5/GP5 Series Technical Manual

efesotomasyon.com - Control Techniques,emerson,saftronics -ac drive-servo motor
Chapter 13: Digital Operator Monitor Display

13.1 Digital Operator Monitor Display

The following table shows the contents of the Digital Operator monitor display.
LED Name
Fref Frequency reference
Fout Output frequency
Iout Output current
kWout Output voltage
FWD/REV RUN
F/R
command
Montr Monitor
Firmware – S2011 and S3012
Revision: 1 (9/98)
Table 28 Digital Operator Monitor Display
•
Frequency reference can be monitored/set.
•
Setting/display unit depends on display mode (n024).
•
Output frequency can be monitored.
•
Display unit depends on display mode (n024).
Output current can be monitored in units of 0.1 A (1 A for 1000 A and above).
Output voltage can be monitored in units of 0.1 kW (1 kW for 1000 k and above).
•
FWD/REV RUN command can be set/monitored.
•
Setting enabled during RUN command from Digital Operator.
•
FWD run displays For, REV run displays rev.
The following contents can be monitored.
No.
Frequency reference (same as Fref)
U−01
Output frequency (same as Fout)
U−02
U−03 Output current (same as Iout)
U−04 Output voltage reference can be monitored in units of 1 V
DC voltage can be monitored in units of 1 V
U−05
Output power (same as kWout)
U−06
Input terminal status can be monitored (Terminals S1 to S6)
U−07
Inverter status can be monitored
U−08
92
Description
Contents
© Saftronics, Inc.