efesotomasyon.com - Control Techniques,emerson,saftronics -ac drive-servo motor
Chapter 1: Receiving
•
Do not install or operate any Inverter which is damaged or has missing parts. Failure to observe this may result in personal injury or
equipment damage.
1.1
Inspections Checkpoints
1.1.1
Receiving Checkpoints
Does the Inverter model number correspond with the purchase
order?
Are any parts damaged?
Is hardware properly seated and securely tightened?
Was an instruction manual received?
If any of the above checkpoints are not satisfactory, contact your Saftronics representative.
1.1.2
Checking the Nameplate Data
§
Nameplate Data
§
Model Designation
Firmware – S2011 and S3012
Revision: 1 (9/98)
CAUTION
Table 1
Checkpoints
Figure 1 Nameplate Data
U
FP5/GP5
Figure 2 Model Designation
Checkpoints
Check the model number on the nameplate on the side of the
FP5/GP5. (See below.)
Visually check the exterior and verify that there was no
damage during transport.
Remove Inverter front cover. Check all visible hardware with
appropriate tools.
FP5/GP5 Instruction Manual
2
Description
© Saftronics, Inc.