Connection Diagram - Saftronics FP5/GP5 Series Technical Manual

efesotomasyon.com - Control Techniques,emerson,saftronics -ac drive-servo motor
Chapter 3: Wiring
•
Only commence wiring after verifying that the power supply is turned OFF. Failure to observe this can result in an electrical shock or
fire.
•
Wiring should be performed only by qualified personnel. Failure to observe this can result in an electrical shock or fire.
•
When wiring the emergency stop circuit, check the wiring thoroughly before operation. Failure to observe this can result in personal
injury.
•
Verify that the Inverter rated voltage coincides with the AC power supply voltage. Failure to observe this can result in personal injury
or fire.
•
Do not perform a withstand voltage test of the Inverter. It may cause semi-conductor elements to be damaged.
•
To connect a Braking Resistor, Braking Resistor Unit or Braking Unit, follow the procedures described in Chapter 11. Improper
connection may cause fire.
•
Tighten terminal screws to the specified tightening torque. Failure to observe this can result in a fire.
3.1

Connection Diagram

Below is a connection diagram of the main circuit and control circuit. Using the Digital Operator, the motor can be operated by
wiring the main circuit only.
Firmware – S2011 and S3012
Revision: 1 (9/98)
WARNING
CAUTION
FP5/GP5
Figure 9 FP5/GP5 Connection Diagram
10
© Saftronics, Inc.