Parts Replacement And Adjustment; Procedures; Air Filter Maintenance; Fluid Filter Maintenance - Sullair LS-200S Operator's Manual And Parts List

Section 7
MAINTENANCE
Figure 7-2 Compressor Fluid Filter (P/N 02250054-605)
* Repair Kit P/N 250025-526
should be changed under the following conditions,
whichever occur first:
1. Every 1800 hours.
2. Once a year.
3. As indicated by fluid analysis.
A fluid sample at every 1000 hours is recommend-
ed. For a free Sullube analysis, send fluid to:
Dow Chemical
Lubricant Technology Center
Building B-1605
Freeport, TX 77541
To facilitate this, a sample bottle is included with the
compressor.

7.7 PARTS REPLACEMENT AND ADJUSTMENT

PROCEDURES

Please familiarize yourself with the safety guide-
lines offered in Section 1- Safety
before attempting any maintenance on the pack-
age.

AIR FILTER MAINTENANCE

Refer to Figure 7-1. Air filter maintenance on air fil-
ter no. 02250135-154 should be performed when
the Supervisor displays Air Filter Maint, or once a
year, whichever comes first. If the filter needs to be
replaced, order
02250135-155. Consult the following procedures to
replace the air filter element.
AIR FILTER ELEMENT REMOVAL
1. Clean exterior of air filter housing.
38
of this manual
replacement element
2. Release the three retaining clamps and remove
the end cap.
3. Remove element and clean interior of housing
using a damp cloth.
DO NOT blow dirt out of housing with com-
pressed air.
ELEMENT REPLACEMENT
1. Element replacement is performed by reversing
the removal instructions. Make sure that the ele-
ment is fully seated into the housing.

FLUID FILTER MAINTENANCE

Refer to Figure 7-2. Fluid filter maintenance should
be performed when one or more of the following
items occurs:
• When corresponding maintenance message
is displayed by the Supervisor - this corre-
sponds to a pressure loss condition across
Figure 7-3 Separator Element Replacement
no.
* Replacement Element P/N 250034-085 (primary)
** Replacement Element P/N 02250145-897
(secondary)