R&S SGS100A Getting Started page 37

®
R&S SGS100A
● Microsoft Internet Explorer 9 or later
To connect to the R&S SGS from an external device, both of them must have
access to the same network, i.e. use a shared network.
The feature set of the R&S SGS100A Web-GUI is limited to the most common
settings, needed especially for modifying the output signal. For additional actions
like firmware updates or adjustments, please use the R&S SGMA-GUI.
You can operate the R&S SGS100A Web-GUI and the R&S SGMA-GUI simulta-
neously. Furthermore you can enable the "Update" function (upper right corner) to
allow an automatic update of the settings shown in the R&S SGS100A Web-GUI,
if the settings were changed via other software.
As a prerequisite for this example, the R&S SGS has to be connected to the
same network as the device used for controlling the instrument. Also one of the
supported web browsers has to be available.
1. Check the front panel of the R&S SGS.
The [POWER ON /STAND BY] and the [LAN] key have to be green.
2. Open a supported web browser.
3. Enter the instrument name or the IP address of the R&S SGS you want to
connect to.
Tip: The default hostname of the instrument is a non case-sensitive string
built as follows:
hostname = rssgs100a<serial number>, where
<serial number> is the individual serial number of the instrument.
The serial number is displayed at the rear side of the instrument. It is the third
part of the device ID printed on the bar code sticker, see
Figure 4-2: Serial number of the R&S SGS100A
The main panel of the R&S SGS100A Web-GUI opens.
Getting Started 1416.0570.02 ─ 11
Configuring a CW Signal with the R&S SGS100A Web-GUI
First Steps with the Instrument
Figure 4-2.
35