Output Rate; Functional Check - Valeport Hyperion Operating Manual

Fluorometer

Table of Contents

Data Acquisition

4.2. Output Rate

The signal output can be configured between 0.5 Hz and 32 Hz (free running) using software control.

The unit is factory pre-set to the maximum synchronous averaging period (0.5 Hz or 2 secs) in order

to be able to resolve the minimum detection limit.

Fast data rates should only be used w here good signal levels are encountered, otherwise features

may be lost in the background noise. In very low signal conditions, signal:noise ratio issues w ill,

therefore, limit the maximum vertical speed and resolution w hen running profiles.

To perform a functional test connect the Hyperion to both pow er and PC using the supplied Y

cable.

Run DataLog x2, available from the Valeport Website as a free download - www .valeport.co.uk/

Products/DataLog x2

Connect the Hyperion to DataLog or Terminal x2 using the connect w izard:

Once connected, use the Configure w izard to set the instrument up:

Select your Comm Port, then select Next:

Page 13

Table of Contents