Hash (#) Codes - Valeport Hyperion Operating Manual

7.3. Hash (#) Codes

Hash codes are used to configure the instrument. They can be applied using a Terminal program or
DataLog x2 software
# Code Variable
#001 address_485
#002 address_485
#005 address_mode
#006 address_mode
#015 last_measure
#022 cal_date
#028 run
#032 version
#034 serial_number
#037 site_info
#038 site_info
#039 set_sampling_mode
#040 last_sampling_mode
#059 baud_rate
#082 rs_485_selected
#083 rs_485_selected
#102 user_output
#103 user_output_dummy_out
#104 user_format
user_format_dummy_out
#105
#126 parameter_id
#128 parameter_units
#222 averaging_constant
#223 averaging_constant
#401 fluoro_gain
Page 21
Description
Sets the address value for addressed system
Reads the address value for addressed system
Turns on or off address mode 0 = Off 1 = On
Reads address mode on or off
Request last measurement
Reads ASCII string of the last cal date
Place unit into run mode
Reads the firmware version of the instrument
Reads the serial number of the instrument
Enter site information
Read the site information
Set sampling mode without running
Read last sampling mode
Baud rate. 2400,4800,9600,19200,115200 or 230400
Selects if in RS485 mode. Usually done with control line
Read status
Enter output item
Read output item
Enter 'c' style format string
Read format string
Read parameter id
Read units
Set the number of samples to average
Read the averaging length
Report Fluorometer gain
Communications
© 2018 Valeport Ltd