Table of Contents
Advertisement
Pronar PT610
After the first loading of cable, re-check the condition of cable ends, correct if
necessary.
FIGURE 5.7
Installation of steel cable clamps
Adjustment of parking brake cable tension
Hitch trailer to tractor. Park trailer and tractor on level surface.
Place chocks under trailer rear wheel.
Unscrew the brake bolt mechanism maximally (1) – figure (5.6), (anti
clockwise).
Loosen nut (6) of cable clamps (5) of parking cable (2).
Tighten cable and tighten clamps.
Checking and/or adjustment of parking brake:
5.3 PNEUMATIC SYSTEM MAINTENANCE
5.3.1
PRELIMINARY INFORMATION
Work connected with repair, replacement or regeneration of system components (brake
cylinders, conduits, control valve, braking force regulator, etc.) should be entrusted to
Length of parking brake cable should be so selected that at total
release of working and parking brake the pulley block would be loose
and hanging by 1 - 2 cm compared to fully tensioned cables.
• every 12 months,
• if needed.
5.16
SECTION 5
Advertisement
Table of Contents
