Teach-In With Changed Threshold Values - Roland Double Sheet Detector I100 Manual

Start-up
6.8

Teach-In with changed threshold values

This function should only be performed if different threshold settings are to be used.
Preparation:
Step 1
Fig. 28: Calling up the setup mode
Step 2
Fig. 29: Calling up a change
Step 3
Fig. 30: Performing the Teach-In with modified values
Has the function been executed, the system automatically changes to the measurement mode and
shows the new thresholds.
If the function could not be executed, a fault message appears in the LCD display.
Pos: 33 /Doppelblech/Geräte/R1002/6 Inbetriebnahme / Bedienung/Externer Teach-In @ 0\mod_1184850392984_501.doc @ 4150 @
ROLAND ELECTRONIC GmbH · Otto-Maurer-Str. 17 · DE 75210 Keltern · Phone +49 (0)7236-9392-0 · Fax +49 (0)7236-9392-33
36
Double Sheet Detector R100 I100
A100: Place the sensor on the sheet.
I100: Place the sheet between the sensors.
R100structure.bmp
Press the key "change".
R100TChHandChange.bmp
Press the key "renew".
By pressing the key "renew" the Teach-In will be performed with the
modified settings.
The current measurement value is stored as reference value.
Based on the reference value the absolute values for the thresholds L
and U are calculated with the modified relative factors and be stored
also.
Manual
for pairs of sensors
Press the key "setup".
R100TChangeHandRenew.bmp
B0003308 / 1.4 / 13.02.2013