Teach-In With Changed Threshold Values - Roland R100 Series Manual

Start-up
6.8

Teach-In with changed threshold values

This function should only be performed if different threshold settings are to be used.
Preparation:
Step 1
Fig. 20: Calling up the setup mode
Step 2
Fig. 21: Calling up a change
Step 3
Fig. 22: Performing the Teach-In with modified values
Has the function been executed, the system automatically changes to the measurement mode and
shows the new thresholds. If the function could not be executed, a fault message appears in the
LCD display.
30 ROLAND ELECTRONIC GmbH · Otto-Maurer-Str. 17 · DE 75210 Keltern · Phone +49 (0)7236-9392-0 · Fax +49 (0)7236-9392-33
Double Sheet Detector R100-Serie A100
for single sided sensors
A100: Place the sensor on the sheet.
I100: Place the sheet between the sensors.
R100structure.bmp
Press the key "change".
R100TChHandChange.bmp
Press the key "renew".
By pressing the key "renew" the Teach-in will be performed with the
modified settings.
The current measurement value is stored as reference value.
Based on the reference value the absolute values for the thresholds L
and U are calculated with the modified relative factors and be stored
also.
Manual
Press the key "setup".
R100TChangeHandRenew.bmp
B0003306 / Rev. 1.0