SawStop RT-PHFS Owner's Manual page 32

Insert a T-bolt (4.8) through a router
14
fence guard spacer (4.16), with the
square part of the spacer adjacent the
head of the T-bolt and the rounded part
of the spacer facing away from the head
of the T-bolt. Repeat this process with
another T-bolt (4.8) and another router
fence guard spacer (4.16). Slide the
router fence guard (4.15) onto the two
T-bolts, so the rounded parts of the
spacers extend into the elongated
vertical holes in the router fence guard.
Secure each T-bolt (4.8) with an M6
washer (4.7) and a fence face plate lock
knob (4.6). Do not tighten the lock knobs.
Slide the heads of the T-bolts into the
15
top T-slot in the front of the vertical
section of the router fence (4.1). The
semicircular, bent portion of the router
fence guard (4.15) should face away from
the router table fence. The height of the
router fence guard relative to the router
table can be adjusted by loosening the
lock knobs, moving the router fence
guard up or down, and retightening the
lock knobs.
27
RT-FS/RT-PHFS OWNER'S MANUAL
4.15
4.7
4.6
4.8
4.16
4.1
4.15