SawStop RT-PHFS Owner's Manual page 31

Slide the T-slot in the back of a router
11
fence face plate (4.14) onto three of the
T-bolts (4.8) you just installed.
Slide the other router fence face plate
12
(4.14) onto the other three T-bolts (4.8)
you just installed. The router fence face
plates should cover the entire front of the
router fence at this time.
Tighten the six lock knobs (4.6) to secure
13
the router fence face plates (4.14). To
adjust the router fence face plates,
loosen the lock knobs on the back of
the fence and slide the router fence face
plates away from each other until they
do not interfere with the router bit, then
retighten the lock knobs.
ALWAYS MAKE SURE THE LOCK KNOBS ARE FULLY TIGHTENED BEFORE
USING THE FENCE!
4.8
4.14
4.8
4.6
RT-FS/RT-PHFS OWNER'S MANUAL
4.14
4.6
26