SawStop RT-PHFS Owner's Manual page 30

Next, you will assemble and install the
8
32" fence. Thread a ¼" pan head Phillips
screw (4.11) into one of the two holes on
the side of the 2 ½" dust port (4.10), then
thread a ¼" square nut (4.12) partway
onto the end of the screw. Repeat this
process with another ¼" pan head
Phillips screw and ¼" square nut, but
thread the screw in the hole on the other
side of the dust port.
Slide the two ¼" - 20 square nuts (4.12)
9
into the lower T-slot on the back of the
router table fence (4.1) until the dust
port is aligned with the large opening
in the back of the fence. Use a Phillips
screwdriver to tighten the screws to
secure the dust port to the router
table fence.
Insert a T-bolt (4.8) through one of the
10
six holes in the vertical portion of the
router table fence (4.1), so the head of
the T-bolt is on the front of the fence
(the side with three T-slots) and the
threaded portion of the T-bolt is on
the rear of the fence (the side with two
T-slots and the bent edge). Slide an M6
washer (4.7) onto the end of the T-bolt
and then thread a fence face plate lock
knob (4.6) onto the T-bolt, until the end
of the T-bolt is flush with the outer edge
of the lock knob. Repeat this process for
the remaining five holes in the vertical
portion of the router table fence.
25
RT-FS/RT-PHFS OWNER'S MANUAL
4.12
4.12
4.1
4.7 4.6
4.8 4.1
4.11
4.10