Assembling The Fence - SawStop RT-PHFS Owner's Manual

Assembling the 32" Fence Assembly
Requires:
32" Fence Components and Hardware
Phillips Head Screwdriver
5mm Hex Wrench
10mm Wrench
Level or Straightedge
Assemble and install the rails: Insert a
1
hex head bolt (4.21) through a washer
(4.7), then through one of the elongated
holes in a rail (4.18) and partway into a
square nut (4.12). Repeat this process for
the other two elongated holes in the rail.
Slide the three square nuts (4.12) into the
2
T slot in a rail mounting bracket (4.20).
Make sure the elongated holes in the rail
mounting bracket (4.20) are on the top
edge. Use a 10mm wrench to tighten the
hex head bolts (4.21).
Place the rail and bracket on the side of
3
your router table, so the four holes in the
rail mounting bracket align with the four
threaded holes in the underside of the
router table. Use four socket head cap
screws (4.23) to secure the rail mounting
bracket (4.20) to the underside of your
router table. Hold the 32" table rail flush
with the edge of your router table, and
use a 5mm hex wrench to tighten the
four socket head cap screws (4.23).
23
RT-FS/RT-PHFS OWNER'S MANUAL
4.12
4.18
4.7
4.21
4.12
4.20
4.23
4.20