H3C S3610 Series Command Manual page 10

Command Manual – BFD-GR
H3C S3610&S5510 Series Ethernet Switches
View
Any view
Parameters
verbose: Displays detailed session information.
slot slot-id: Displays the session information of the specified board/slot.
Description
Use the display bfd session command to display BFD session information. This
command displays the following interface-related information: session local ID, session
remote ID, source address, destination address, session state, length of time before
session detection timer expires, and the name of the interface of the session.
Besides the information displayed by the display bfd session command (except the
length of time before session detection timer expires), the display bfd session
verbose command displays:
Minimum transmit interval, minimum receive interval, actual transmit interval, actual
session detection timer, packets sent and received by the session, time when the
session was established, last time when the session was down, last time when the
session was up, authentication mode, connection type, registered protocol, and
diagnostic information.
Examples
# Display information about all the BFD sessions.
<Sysname> display bfd session
Total Session Num: 1
Session Working Under Echo Mode:
LD
1
# Display detailed information about the sessions maintained by the device.
<Sysname> display bfd session verbose
Total Session Num: 1
Session Working Under Echo Mode:
Local Discr: 1
Source IP: 192.168.0.136
Session State: Up
Min Recv Inter: 400ms
Act Detect Inter: 2000ms
Init Mode: Active
SourceAddr DestAddr
192.168.0.136 192.168.0.138
Init Mode: Active
1-9
Chapter 1 BFD Configuration Commands
State Holdtime Interface
Up 1700ms
Destination IP: 192.168.0.138
Interface: Vlan-interface1
Act Trans Inter: 400ms
Hold Time: 1700ms
Vlan1