Care of Sweden CuroCell 4 User Manual page 10

4.4 Alarms
When the pressure in the mattress drops to an abnormally low level, the yellow low pressure
lamp lights and an acoustic alarm sounds.
First, check that the CPR valve is closed and that all connections are intact and correctly
installed in accordance with paragraph 3. The yellow LED blinks until the pressure is corrected
and restored.
The alarm is deactivated by pressing the alarm off button. If the problem is not resolved within
3 minutes, the alarm will sound again.
and reset.
See section 8 for troubleshooting.
WARNING!
If the air pressure remains low, check the mattress and tubes for damage. Repair if
necessary or contact the manufacturer or your local dealer for help.
4.5 CPR
In the event of an emergency requiring CPR (cardiopulmonary resuscitation):
CPR strap, remove the quick connectors at the side of the pump to deflate the mattress as fast
as possible. On this product, there are two possible positions for the CPR valve – at the head
end (1a) or the foot end (1b).
Position 1a.
At the head end of the mattress,
on the right side (user's right hand side).
NOTE: This connector is held in place with the
elastic
Note! Make sure that the CPR valve is properly connected after use.
4.6 Transport function
If the patient must be
connected together (detached from the pump) and the
mattress put in "transport mode".
mode only for short periods of time.
The yellow lamp flashes until the pressure is corrected
strap.
moved in bed, the tubes can be
We recommend using this
Position 1b.
On tubes, between the
pump and mattress.
10
Quickly pull the