Charging The Battery Pack - Sony DCR-TRV40 Operating Instructions Manual

Step 1 Preparing the power supply

Charging the battery pack

Use the battery pack after charging it for your camcorder.
Your camcorder operates only with the "InfoLITHIUM" battery pack (M series).
See page 223 for details of "InfoLITHIUM" battery pack.
(1) Open the DC IN jack cover and connect the AC power adaptor supplied with
your camcorder to the DC IN jack with the plug's v mark facing up.
(2) Connect the power cord to the AC power adaptor.
(3) Connect the power cord to the wall outlet.
(4) Set the POWER switch to OFF (CHG). Charging begins. The remaining battery
time is indicated in minutes on the display window.
When the remaining battery indicator changes to
fully charge the battery (full charge), leave the battery pack attached for about one hour
after normal charge is completed until FULL appears in the display window. Fully
charging the battery allows you to use the battery longer than usual.
2
After charging the battery pack
Disconnect the AC power adaptor from the DC IN jack on your camcorder.
16
, normal charge is completed. To
1 4
VCR
OFF(CHG)
CAMERA
MEMORY/
NETWORK