Maintenance information and precautions
Adjusting the LCD screen (CALIBRATION)
The buttons on the touch panel may not work correctly. If this happens, follow the
procedure below.
(1) Set the POWER switch to OFF (CHG).
(2) Eject the cassette from your camcorder, then disconnect any connecting cable
from your camcorder.
(3) Set the POWER switch to VCR while pressing DISPLAY/TOUCH PANEL on
your camcorder, then keep pressing DISPLAY/TOUCH PANEL for about five
seconds.
(4) Follow the procedure below using an object such as the corner of a "Memory
Stick" supplied with your camcorder.
You can use the supplied stylus for this operation (DCR-TRV50 only).
1 Touch
2 Touch
3 Touch
CALIBRATE
Note
If you do not press the right spot,
corner. In this case, start from step 4 again.
230
at the upper left corner.
at the lower right corner.
in the middle of the screen.
CALIBRATE
always returns to the position at the upper left
CALIBRATE
PB
INDEX
FN