Inserting A Scene From A Vcr - Insert Editing - Sony Handycam DCR-PC101 Operating Instructions Manual

Inserting a scene from a VCR
– Insert editing
You can insert a new scene from a VCR onto your originally recorded tape by
specifying the insert start and end points. Use the Remote Commander for this
operation. Connections are the same as on page 97 or 98 .
Insert a cassette containing the desired scene to insert into the VCR.
[A]: A tape that contains the scene to be superimposed
[B]: A tape before editing
[C]: A tape after editing
(1) Set the POWER switch to VCR.
(2) On the VCR, locate just before the insert start point [a], then set the VCR to
playback pause.
(3) On your camcorder, locate the insert end point [c] by pressing m or M.
Then set it to playback pause.
(4) Press ZERO SET MEMORY on the Remote Commander. The ZERO SET
MEMORY indicator flashes and the end point of the insert is stored in
memory. The tape counter shows "0:00:00."
(5) On your camcorder, locate the insert start point [b] by pressing m. Press FN
and select PAGE3, then press REC CTRL. And press REC PAUSE.
(6) First press X on the VCR, and after a few seconds press REC START on your
camcorder to start inserting the new scene.
Inserting automatically stops near the zero point on the tape counter. Your
camcorder automatically stops recording.
100
[A]
[B]
[C]
[a]
[b] [c]