Sony Handycam DCR-PC101 Operating Instructions Manual page 89

Dubbing only desired scenes – Digital program editing (on tapes)
(2) Setting the modes to cancel the recording pause on the
VCR
1 Press r/R to select PAUSEMODE, then press EXEC.
2 Press r/R to select the mode to cancel recording pause on the VCR, then
press EXEC.
The correct button depends on your VCR.
Refer to the operating instructions of your VCR.
1
V I DEO ED I T
ED I T SET
CONTROL
ADJ TEST
"CUT - I N"
"CUT -OUT"
I R SETUP PAUSE
REC
PAUSEMODE
I R TEST PB
EXEC
Buttons that cancel recording pause on the VCR
The buttons vary depending on your VCR. To cancel recording pause of your VCR:
– Select PAUSE if the button to cancel recording pause is X.
– Select REC if the button to cancel recording pause is z.
– Select PB if the button to cancel recording pause is N.
(3) Locate the infrared rays emitter of your camcorder and
face it towards the remote sensor of the VCR
Set the devices about 30 cm (12 in.) apart, and remove any obstacles between the
devices.
2
END
V I DEO ED I T
ED I T SET
CONTROL
ADJ TEST
"CUT - I N"
"CUT -OUT"
I R SETUP
PAUSEMODE
I R TEST
RET.
Infrared rays emitter
Remote sensor
A/V connecting cable (supplied)
END
PAUSE
EXEC RET.
VCR
89