Sony Handycam DCR-PC101 Operating Instructions Manual page 170

Connecting to your computer with USB port – For Windows users
(11) Follow the on-screen messages so that the Add Hardware Wizard recognizes
For Windows 2000 Professional, Windows XP Home Edition/Professional users
(12) After the "File Needed" screen appears:
Viewing images recorded on "Memory Stick"s on your
computer
Before operation
Set USBCONNECT to NORMAL in the menu settings. (The default setting is set to
NORMAL.)
(1) Insert a "Memory Stick" into your camcorder.
(2) Connect the AC power adaptor to your camcorder and set the POWER switch
(3) Connect the
(4) Follow the on-screen messages so that the Add Hardware Wizard recognizes
You cannot install the USB driver if a "Memory Stick" is not in your camcorder.
Be sure to insert a "Memory Stick" into your camcorder before installing the USB
driver.
170
that the USB drivers have been installed. The Add Hardware Wizard starts
three times because three different USB drivers are installed. Be sure to allow
the installation to complete without interrupting them.
Open "Browse..." t "My Computer" t "ImageMixer" t "Sonyhcb.sys",
and click "OK".
to MEMORY.
(USB) jack on your camcorder with the USB port on your
computer using the supplied USB cable.
USB MODE appears on the LCD screen of your camcorder. Your computer
recognizes the camcorder, and the Add Hardware Wizard starts.
(USB)
Push into the end
that the USB drivers have been installed. The Add Hardware Wizard starts
two times because two different USB drivers are installed. Be sure to allow
each installation to complete without interrupting them.
USB cable (supplied)
USB port