Sony Handycam DCR-PC101 Operating Instructions Manual page 96

Dubbing only desired scenes – Digital program editing (on tapes)
Operation 2: Performing Digital program editing
(Dubbing a tape)
Make sure your camcorder and the VCR are connected, and that the VCR is set to
recording pause. When you use an i.LINK cable the following procedure is not
necessary.
When you use a digital video camera recorder, set the power switch of VCR to VCR/
VTR.
(1) Press MENU, then select VIDEO EDIT in
(2) Press r/R to select TAPE, then press EXEC.
(3) Press START.
(4) Press EXEC.
To stop dubbing during editing
Press CANCEL.
To finish the Digital program editing function
Your camcorder stops when the dubbing is complete. Then the display returns to
VIDEO EDIT in the menu settings.
Press
You cannot record on the VCR when:
– The tape has run out.
– The write-protect tab on the cassette is set to lock.
– The IR SETUP code is not correct. (When IR is selected.)
– The button to cancel recording pause is not correct. (When IR is selected.)
CHECK "i.LINK" & REC STATUS appears on the LCD screen when:
– i.LINK is selected but an i.LINK cable is not connected.
– The power of the connected VCR is not turned on. (When i.LINK is selected.)
When the program has not been set
You cannot press START.
96
Search for the beginning of the first program, then start dubbing.
The SEARCH indicator appears during search, and the EDITING indicator
appears during edit on the LCD screen.
The program mark changes to light blue after the dubbing is complete.
When the dubbing ends, your camcorder and the VCR automatically stop.
END to end the video edit function.
, then press EXEC (p. 192).