Converter Module Installation; Safety Warnings - Cisco TwinGig CVR-X2-SFP Installation Notes

Converter Module Installation

Safety Warnings

Caution
Warning
78-17572-04
This section describes how to install and remove a converter module in a switch
and how to install and remove the SFP or SFP+ modules. It contains these
sections:
Safety Warnings, page 7
•
Installation Guidelines, page 8
•
Installing and Removing the Converter Module, page 9
•
Installing and Removing SFP or SFP+ Modules, page 12
•
This section includes the basic installation caution and warning statements.
Translations of the warning statements appear in the Regulatory Compliance and
Safety Information for the Catalyst 3750-E and Catalyst 3560-E (available online
at
http://www.cisco.com/en/US/docs/switches/lan/catalyst3750e_3560e/hardware/r
egulatory/compliance/1848201.html) document that ships with the switch. Read
this section before you start the installation procedure.
Proper ESD protection is required whenever you handle Cisco equipment.
Installation and maintenance personnel should be properly grounded by means of
grounding straps to eliminate the risk of ESD damage to the equipment.
Equipment is subject to ESD damage whenever it is removed from the switch.
This warning symbol means danger. You are in a situation that could cause
bodily injury. Before you work on any equipment, be aware of the hazards
involved with electrical circuitry and be familiar with standard practices for
preventing accidents. Use the statement number provided at the end of each
warning to locate its translation in the translated safety warnings that
accompanied this device. Statement 1071
Installation Notes for the Cisco TwinGig and OneX Converter Modules
Converter Module Installation
7